Austwide Solar employs only Clean Energy Council (CEC) accredited designers and electrical engineers who at the same time are all registered electricians. The Austwide Solar design and install team are approved to install both grid-connected and stand-alone solar power systems.
Austwide Solar employs only Clean Energy Council (CEC) accredited designers and electrical engineers who at the same time are all registered electricians. The Austwide Solar design and install team are approved to install both grid-connected and stand-alone solar power systems.
Austwide Solar employs only Clean Energy Council (CEC) accredited designers and electrical engineers who at the same time are all registered electricians. The Austwide Solar design and install team are approved to install both grid-connected and stand-alone solar power systems.
Austwide Solar employs only Clean Energy Council (CEC) accredited designers and electrical engineers who at the same time are all registered electricians. The Austwide Solar design and install team are approved to install both grid-connected and stand-alone solar power systems.
Hipot is an acronym for high Potential which mean high voltage.
The best way to determine this is to check the specification that you must comply with for your test. Typically the “role of thumb” is 2×operating voltage+1000 volt.So if your products’ operating voltage is 115 volt. AC the answer will be 2×115＋1000＝1,230 volt.Test voltage may vary depending upon the classification of the products.
Ground protection consists of two kinds of test method: Ground Continuity test (GC) and Ground Bond test (GB). The purpose of ground protection test is for protecting users from electrical hazards as touching equipment when unsuitable current is created and flows to the earth.
Insulation resistance test and DC withstand test are very similarity, apply DC voltage (50~1000V) to two points of connecting for judging good and no good product. Insulation resistance test is nondestructive test and can detect if insulation is good. In some regulation, do insulation resistance test firstly then withstand test. When insulation resistance test can't pass usually withstand voltage test also can’t pass.
The current is brimmed over as flowing through insulation impedance we called it leakage current, contact by human body and the current through human body flow to Earth then electrical damage is occurred. The difference between leakage current test, withstanding voltage test and grounding protection test is equipment testing under running status. The leakage current adds a human body simulation impedance circuit in testing, it can simulate the quantity of leakage current through human body under real condition.
Ainuo Instrument is widely applied in conventional industries of information, communication, electrical appliance, aviation and military etc. At the same time, it is also complete and efficient test solution for jumped-up hybid electric vehicle, new energy source, fuel cell and smart grid etc. Ainuo Instrument Co., Ltd provides full test and measurement instrument & equipment for power electronics industry including: basic test and measurement instrument like AC Power Supply, DC Power Supply, DC Electronic Load, AC Electronic Load, Integrated Electrical Parameters Digital Measuring Instrument and Electrical Safety Performance Tester etc; integrated industry test system like Power Supply Automatic Test System (ATS), Motor Automatic Test System (MTS), Electrical Safety & Regulations Automatic Test System (STS), Battery Charge And Discharge Test System (BTS); at the same time, provide the customers with open software platform “Teststand”, which is convenient for the customers to independently establish test flows and standards and edit generated test reports and monitor remote test data etc.
